The CNC shearing machine should be inspected regularly for damages, wear (a basic type of component failure), and timely replacement and replenishment of spare parts. The CNC shearing machine is equipped with a movable rear material device and an electronic counter for easy adjustment of the rear material position. The floating blade holder and four-edge long blade are convenient for adjusting the gap between the blades, improving the cutting quality and prolonging the blade usage.
The machine adopts a three-point support shaft dynamic sliding rail, and the upper blade moves without gaps between the sliding rails, and the blade usage can be adjusted by the rolling handwheel. Before each startup, lubricating oil should be added according to the lubricating chart requirements, with clean and sediment-free oil. The CNC shearing machine strictly follows the operating procedures. The electric shearing machine adopts a clutch structure with resistance keys and an open gear drive, and uses advanced electrical appliances (foot switches, manual switches) for operation with low noise and easy maintenance. It adopts a fully welded steel structure, with simple structure, easy operation, beautiful appearance, and low energy consumption. It is widely used in metallurgy, light industry, machinery, hardware, motor, electrical appliance, automobile repair, hardware manufacturing, and other metal sheet processing industries.
The machine tool should be kept clean, and the unpainted parts should be rust-proofed with grease. It adopts a series-parallel cylinder synchronization system, with evenly distributed force on the machine tool. By adjusting the flow rate of the series-parallel cylinder (in cubic meters per second), the shear angle can be easily adjusted to meet the needs of different plate thicknesses. In production, hydraulic punches have the advantages of material and energy savings compared to traditional mechanical processing, high efficiency, low technical requirements for operators, and the ability to produce products that cannot be achieved by mechanical processing using various molds. Therefore, its applications are becoming more and more extensive. The CNC shearing machine should be lubricated and cleaned 10 minutes before the end of work every day.